![]() ![]() I think "POSITION" knob above the, let's say, "CH1 MENU" button sets the position of x-axis. How do I get one waveform? How does it work? But I'm getting two waveforms: one for CH3 and other for CH4. I see CH3 and CH4 are being used to display voltage across the primary. Sometimes I get Trig'd and Ready, and other times Auto and Ready. But CH3 displays correct waveform because it occupies two squares and little bit of third square. But as you can see for CH1 the set scale is 50V/D which means one must get two full boxes (or, squares) and a little bit of third box. Rectified wave should have peak voltage 120V (assuming o-scope shows Vrms). It looks MultiSim virtual models of o-scopes from two difference manufacturers: Tektronix, Agilent. So, I think it's better to ask some questions about it. I have very little experience with real o-scope. Thanks a lot, Jony, Jony: Your attached circuit does work. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |